PCB WD 2060-800002-003 REV P1
  • PCB WD 2060-800002-003 REV P1
  • PCB WD 2060-800002-003 REV P1

FAQ:

Modals REV A, REV B, REV C, REV D, REV E, REV P1, REV P2, 00, 01, 02 are they all compatible with each other?
Yes! They are different board modals, but they are compatible! We will ship you a  randomly selected model. Please leave a message if you wish to receive a specific modal, thank you!
Additional information (Main Controller IC, PCB Label) doesn't match, does it matter ?
No ! Theses details are here for reference, but the same PCB models can have different components, what matters is PCB number
Is this PCB compatible with my HDD ?
We cannot list all HDD models compatible with all PCBs. To find the matching HDD PCB you can unscrew your HDD and find the correct "PCB number". In general a Hard Disk PCB is compatible a whole family of hard drives with different capacities : 20G, 30G, 40G, 60G, 80G, 120G, 160G, 200G, 250G, 300G, 320G, 400G, 500G, 750G, 1TB, 1.5TB, 2TB, 3TB, 4TB.

PCB WD 2060-800002-003 REV P1

€39.90
VAT included

Western Digital 2060-800002-003 REV P1 PCB board for WD hard drives. Please check that the number printed on your board matches exactly before ordering.

Quantity
In Stock

Before buying :

  1. These are just PCBs (Printed Circuit Boards), not the whole HDDs (Hard Disk Drives);
  2. The aim of a PCB swap is data recovery, or hard disk repair,
  3. The buyer is responsible for finding the right PCB for their Hard Drive,
  4. You will benefit from a 14-day return period,
  5. In most cases, you should transfer the BIOS before you swap hard drive PCB, in order to make the replacement board compatible with your HDD. See services below.Transfer possible by Flashing and/or Soldering.
  6. Hard drive failures are not always caused by PCB failure. We cannot guarantee your drive will be repaired by replacing the hard drive PCB.

WD 2060-800002-003 REV P1 PCB board

This product page is for a replacement electronic PCB board for Western Digital hard drives. The PCB number to check is 2060-800002-003, revision REV P1.

  • Brand: Western Digital / WD
  • Category: Western Digital PCB board
  • PCB reference: 2060-800002-003
  • Revision: REV P1
  • Identified compatibility: WD5001FZWX

Check before replacement

A hard drive PCB board must be replaced with an identical reference. Depending on the drive, transferring the BIOS/ROM chip from the original PCB to the replacement board may be required to recover the data.

If you are not sure, use the BIOS transfer / PCB diagnostic service to avoid an incompatibility.

Western Digital
2060-800002-003

Data sheet

With ROM Chip
Yes
flashable
yes, verified on photo
BIOS transfer required
Yes