FAQ:

Modals REV A, REV B, REV C, REV D, REV E, REV P1, REV P2, 00, 01, 02 are they all compatible with each other?
Yes! They are different board modals, but they are compatible! We will ship you a  randomly selected model. Please leave a message if you wish to receive a specific modal, thank you!
Additional information (Main Controller IC, PCB Label) doesn't match, does it matter ?
No ! Theses details are here for reference, but the same PCB models can have different components, what matters is PCB number
Is this PCB compatible with my HDD ?
We cannot list all HDD models compatible with all PCBs. To find the matching HDD PCB you can unscrew your HDD and find the correct "PCB number". In general a Hard Disk PCB is compatible a whole family of hard drives with different capacities : 20G, 30G, 40G, 60G, 80G, 120G, 160G, 200G, 250G, 300G, 320G, 400G, 500G, 750G, 1TB, 1.5TB, 2TB, 3TB, 4TB.

Toshiba G003250A USB PCB

€49.90
VAT included

USB version of the Toshiba G003250A board. Check the interface of your original PCB before ordering.

Supplier-order product, estimated lead time around 2 weeks. Transfer of the original BIOS/ROM chip is mandatory to adapt the board to the drive.

Quantity
Supplier stock, estimated 2-week lead time

Before buying :

  1. These are just PCBs (Printed Circuit Boards), not the whole HDDs (Hard Disk Drives);
  2. The aim of a PCB swap is data recovery, or hard disk repair,
  3. The buyer is responsible for finding the right PCB for their Hard Drive,
  4. You will benefit from a 14-day return period,
  5. In most cases, you should transfer the BIOS before you swap hard drive PCB, in order to make the replacement board compatible with your HDD. See services below.Transfer possible by Flashing and/or Soldering.
  6. Hard drive failures are not always caused by PCB failure. We cannot guarantee your drive will be repaired by replacing the hard drive PCB.

Compatibility and BIOS/ROM transfer

This listing is for the circuit board only, not the complete hard drive. G003250A exists in SATA and USB versions: you must order the version matching the interface of your original PCB. If you are unsure, send us clear photographs of both sides before ordering.

A simple board swap is not sufficient. The BIOS/ROM chip on the original board contains drive-specific data and must be transferred to the replacement board. Do not attempt to desolder the chip unless you have the appropriate equipment and experience.

Workshop service

When the PCB is purchased from our website, BIOS/ROM transfer is offered separately for €25. You may send only your original PCB. Once your board has been received and the supplier PCB is available, the intervention is normally completed within 48 to 72 hours. We can return only the modified PCB or both boards, according to your preference.

Availability and limitations

This product is not held in workshop stock. It is ordered from our supplier with our weekly order, with an estimated lead time of around 2 weeks.

If the ROM chip is damaged or unreadable, we will inform you and refer you to a specialist data-recovery laboratory. Replacing the PCB cannot guarantee data recovery if the drive also has an internal or mechanical fault.

Toshiba
G003250A USB

Data sheet

With ROM Chip
Yes
Interface
USB 3
flashable
No, verified on PCB

You might also like